Heavy Duty No Maintenance Driveway Barrier Gates 4.5M 90 Degree
Folding Arm
WONSUN Barrier Gate
Introduction:
The barrier works well with infrared photocells, loop detectors,
card readers, ticket dispensers, manual switch (wire control), and
traffic light
Barrier motor with die-casting aluminum alloy is high-hermetic and
easy for heat dissipation
Motor cooling fan to avoid the over-heating possibility
Automatic reversing when the barrier boom meets the obstruction
RS485 Communication Module is compatible
Manual release device to operate the barrier when power failure
Driveway Barrier Gates Able to integrate with:
Loop detector.
Photo Cell.
Parking Management System.
Access Control System.
Auto-Close Mode.
Wireless Remote Control (433MHz).
Powder Coated.
Functions:
1. Barrier motor with die-casting aluminum alloy is high-hermetic
and easy for heat dissipation
2. Automatic reversing when the barrier boom meets the obstruction
3. Auto closing realization through menu setting on the control
panel
4. The barrier works well with infrared photocells, loop detectors,
card readers, ticket dispensers, manual switch (wire control), and
traffic light
5. RS485 Communication Module is compatible
.
What are included in this price?
1 pcs Gate Barrier
1 pcs arm boom (from 1m to 6m can customised)
1 pcs control panel(built inside)
2 pcs remote controllers
1 pcs manual book
Arm & Length
| Arm type | Max length |
| Round arm | 4m |
| Straight arm | 8m |
| Telescopic arm | 6m |
| 2 fence arm | 4.5m |
| 3 fence arm | 4m |
| 90 degree folding arm | 4.5m |
| 180 degree folding arm | 4m
|
Our Service :
1. Our Factory has 8 years OEM/ODM experiences in the line of
barrier gate .
2. Prompt delivery time. Usually we keep stock of standard model
which ensure the prompt delivery.
3. We accept OEM/ODM orders to meet the requirements of clients.
4. Trial order is acceptable. Clients can buy sample and test it
before bulk order.
5. Online technical support makes it carefree to be our business
partner.
6. A variety of transportation for your choice. Sea shipment, air
cargo or express, depends on your demand.
7. Factory can be visited on working days. Clients are warmly
welcome to visit our factory.
FAQ:
1. When barrier finish closing, why does the arm open itself
slowly?
- the spring is too tight, you need release the spring a little, then
test it again.
- see whether the main crank touch the triangle tightly or not, if
tightly, adjust it.
- reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal
noises?
- As for this, it means the resistance on controller board is broken,
if you have professional tools to check,
- then replace that broken resistance, if not, replace that
controller panel.
3. Why does the barrier finish half operation of opening and
closing?
- If uses our controller panel, you only need to find resistance R37
on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of
inclination?
- the model is not good, and the gear doesn't fit each other tightly.
- the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order
control, what's the problem?
- To check the loop cable first, because the loop cable maybe brokem
- To check the motor sensor, if it is not set well, then reset it in
the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
- The spring is very tight
- The Screw touches the rubber absorption tightly, need to reset
again.
7. Rubber linning installation suggestion:
- It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
- The place with many vehicles come and go, like shopping center,
carpark area.
8. Can you accept OEM/ODM order?
- Absolutely, we are manufacturer of barrier gate, with 7 years
researching and developing experience.
